Ready Coil and Cartridge E-liquid Leakage or Spitting Solutions
Remove your coil from the device and examine the cotton areas – you'll likely see a soggy, muddy appearance. In such cases, you may experience e-liquid leakage or spitting from your atomizer.
-First of all, avoid leaving e-liquid in the device during the night or for a few idle hours during the day. Otherwise, the cotton continues to absorb the liquid, and once fully saturated, it will begin to leak. Every few days, remove the coil and blow some air through the hole, then leave it to dry.
-Coils, heads, and similar parts must never come into contact with water. These products should not be washed.
IMPORTANT WARNING: This is a critical point emphasized by manufacturers. Do not leave e-liquid in the tank for more than 2 hours or overnight. Liquid can leak into internal components like air sensors or the motherboard, causing irreparable damage.
-Never fill the tank to the top. Fill halfway and top off as needed throughout the day.
-For cartridge-type devices, blow air a few times from the mouthpiece and leave the cartridge to dry.
-With standard models, do the same: blow through the mouthpiece, wipe the coil with a tissue, and let it dry.
-If there's a small amount of liquid left at the bottom, take a few dry puffs. This helps the coil dry out faster. Especially at night, finish the liquid and take 1-2 short puffs to keep the coil dry until morning. Repeat this process between refills as needed.
-Use premium quality e-liquids. Avoid cheap, homemade liquids from unreliable sources – they saturate the coil and cartridge quickly, leading to persistent leaking.
-Always use genuine coils and liquids. Avoid counterfeit products.
Wrap your coil in a tissue and blow hard 10-15 times into the top opening.
After blowing, you’ll notice moisture on the tissue – this process helps remove excess liquid the coil has absorbed.
Reattach the coil cap, fill the atomizer with e-liquid, and continue using it. You should notice that leaking and spitting have stopped. You can repeat this method whenever you encounter leakage issues.
