This article will answer your questions such as why e-liquid splashes when using an electronic cigarette and what the solutions are. E-liquid splashing, which is a big problem for e-cigarette users, has been prevented.

There are engineering solutions in almost all electronic cigarette models to prevent this situation. However, some small technical errors can cause this problem.

During electronic cigarette use, some technical drawing errors cause liquid to get into the mouth and splash.

Why Does the Atomizer Coil Burn Out Quickly?

The bitter taste and burning sensation in the throat that occurs during the first use of an electronic cigarette result from the loss of properties in the cotton and wire within the coil. The sole reason for this is firing immediately after adding the coil to the atomizer section.

If you experience this, you may need to install a new coil and try vaping again.

How Should Proper Usage Be?

When you first start using your electronic cigarette device or after installing a new coil, you should drip 4-5 drops of liquid into the holes on the sides of the coil until the cotton is saturated. After this, you should wait at least 10 minutes. For regular devices, it's necessary to take light draws similar to a cigarette, and for mod devices, it's necessary to start using at a 15W setting. These precautions will help protect your coil.

Another reason is accidentally holding down the power button of the device with your finger. By paying attention to this, you should only press the button during inhalation and release it as soon as the inhalation is complete.

Reasons for E-Liquid Splashing in Electronic Cigarettes

E-liquid splashing in electronic cigarettes is a common issue, especially among new users.

In mod devices, this problem usually arises from incorrect drawing technique and not adjusting the airflow correctly when bringing the device to the lips. The following points should be noted in this regard:

• Never refill liquid when your e-cigarette is hot; this causes splashing due to the combination of hot and cold.
• Do not take sudden draws from devices that have not been used for a long time; the first draws should start with 2-second pulls, and then you can begin normal vaping.
• Blocked airflow causes liquid splashing. To fix this, turn the device 180 degrees and inhale without pressing the firing button. After doing this, you can clean the mouthpiece with a dry tissue and use it again. Liquid may get into your mouth during this process, but it will completely disappear after a few minutes.
• You should use the coil according to your drawing style. Determine your coil based on whether you prefer direct-to-lung or mouth-to-lung vaping.
• Wait about 3 seconds between each draw; it is very important for the atomizer and coil to reset. This is crucial for the longevity of your device.

The above suggestions should be taken into consideration to help eliminate or alleviate the problem of liquid splashing, which is one of the major issues when using electronic cigarettes.